Heating fixed properly, diagnosed before we ring your doorbell.
Dave Bowline repairs domestic boilers and unvented hot water systems across South East London. Send a photo of the boiler display and fault code so Dave arrives with the right replacement parts on van stock.
Eighteen years repairing domestic gas boilers and unvented cylinders in SE London. Carries genuine manufacturer spares on van stock.
Neat soldered copper heating manifold and magnetic system filter on a utility room wall
Organised shelving in the back of a tradesperson's van with copper fittings and boxed components
For active leaks or total heating failure, use the emergency Tap to Call link (020 7946 0831) or send a WhatsApp photo of your boiler casing, model badge, and fault code (such as F28, EA, or F75) so Dave pulls the matching pump head, sensor, or diverter valve before setting off.
We charge a fixed £70 first-hour diagnostic fee. If the repair requires replacement components, Dave quotes the exact parts cost and any additional labour before opening any toolboxes.
We stay strictly within four miles of the Greenwich meridian. Keeping travel times under 20 minutes ensures we arrive when promised without rescheduling appointments.
Submit the enquiry form with your boiler make and display code so we verify parts availability before confirming a slot.
We give you a two-hour arrival window and telephone 20 minutes ahead when leaving the previous property.
Dave tests the system, explains the fault, and agrees on exact parts costs before commencing repairs.
The heating system is run up to full operating temperature, flue readings checked, and an itemised receipt emailed.
Based near Greenwich station, serving homes within a 4-mile radius so arrival times stay realistic:
Turn off the cold water mains stopcock (usually under the kitchen sink) and turn off the fused spur switch beside the boiler. Call Dave directly on 020 7946 0831.
The £70 diagnostic fee covers one hour of electrical and hydraulic fault-finding. If the heat exchanger is cracked or parts are obsolete, we explain why in writing and outline replacement options.
We only fit new genuine manufacturer parts sourced through verified trade merchants. This ensures correct specification, component safety, and traceability.
Unvented cylinders need an engineer with the right G3 qualification. On a real site this answer names the engineer’s actual qualification, checked with them before anything is published.